Reductive leaching of manganese from low-grade manganese ore using xanthan gum wastewater as reductant. Xi Xiao-la. Environmental Science, Chemistry. …
It was demonstrated that the leaching of manganese was controlled by the chemical surface reactions and the activation energy which equals 115.9121 kJ/mol. In this study, the oxidation of low-grade pyrolusite to potassium manganate in alkaline solutions under O2 pressure has been investigated. ... Manganese ore JM-2 was low grade and …
In the present investigation results on the use of dried leaves as a reductant for manganese ore leaching is reported. A complete flow-sheet consisting of steps such as reductive acid leaching, enrichment of leach solution by recycling, iron removal and crystallization has been developed for the preparation of manganese sulphate …
Manganese was leached from a low-grade manganese ore (LGMO) using banana peel as the reductant in a dilute sulfuric acid medium. The effects of banana peel amount, H2SO4 concentration, reaction temperature, and time on Mn leaching from the complex LGMO were studied. A leaching efficiency of ∼98% was achieved at a …
The reductive leaching of manganese from low-grade manganese ore( 20. 5% Mn) in dilute sulfuric acid in the presence of xanthan gum wastewater is investigated. The effects of solid-to-liquid … Expand
The reductive leaching of manganese ore in the presence of dilute sulphuric acid and powdered sponge Fe metal was investigated by the same research group (Bafghi et al., 2008). The dissolution efficiency was studied using various parameters such as …
The leaching kinetics of reductive leaching of manganese from manganese dioxide ores (MDO) in dilute sulfuric acid in the presence of Phytolacca americana powder (PAP) was investigated. The effects of stirring speed, leaching temperature and leaching time, particle size, weight ratio of PAP to MDO (C W) and sulfuric acid concentration (C …
Since the pH of the final solution of manganese sulfate was approximately 7.0 and the average recovery of manganese was 95.5%, the leaching of 0.1000 g of manganese ore waste with sulfuric acid produced 0.0972 g of a solid containing manganese sulfate and other elements such as Ca, Mg and K, which can be …
XPS diagram of manganese ore leaching slag; (a) the full spectrum of leaching slag, (b) Mn spectrum. Scanning electron microscopy (SEM) was performed on the leaching residue to analyze the microstructure of the manganese ore and the leaching residue. The result is shown in Fig. 6. In the scanning electron microscope image of the …
The reduction leaching process of manganese ore tailing: First, a 250 mL three-necked flask was immersed in a constant temperature water bath, and furnished with a mechanical stirring device, a thermometer, and a reflux condenser. The leaching agent (hydrochloric acid, HCl) was added to the three-necked flask and heated up to the …
Material. The low-grade manganese ore used in this study was obtained from Wan Yuan, Sichuan Province, China. The chemical composition and X-ray diffraction pattern are given in Table 1 and Fig. 2, respectively.The material is a typical low-grade manganese carbonate ore, and the mass fraction of manganese is only 17.83%.
In this study, corncob was used as reductant for sulfuric acid leaching of manganese ore from Daweezi, Upper Mohmand Agency, Pakistan. X-ray diffraction of representative powdered samples revealed the presence of manganese silicate MnSiO(SiO4), calcite (CaCO3), and -quartz (SiO2). X-ray diffraction and energy dispersive spectroscopy …
1. Introduction. Manganese is an irreplaceable material in the steel industry (Sun et al., 2020, Sahoo et al., 2001).At present, about 95% of the manganese produced every year is used in the steel industry as a unique deoxidizing and desulfurizing agent to improve the quality of steel (Jacob et al., 2020, Liu et al., 2019).With the depletion of …
A rich manganese ore from Chalkidiki (Greece) was leached in aqueous SO 2 solutions at atmospheric pressure and ambient temperature to extract more than 95% Mn after 10 min. Process conditions, such as SO 2 concentration, time, pH, agitation rate, temperature and pulp density were investigated. Low impurities of iron in the pregnant …
The kinetics of reductive leaching of manganese from a low-grade manganese oxide ore were studied using cellulose as reductant in dilute sulfuric acid medium. It was found that when the stirring speed was higher than 200 r/min, the effect of gas film diffusion on manganese extraction efficiency could be neglected, and the …
Cornstalk is usually directly used as a reductant in reductive leaching manganese. However, low utilization of cornstalk makes low manganese dissolution ratio. In the research, pretreatment for cornstalk was proposed to improve manganese dissolution ratio. Cornstalk was preprocessed by a heated sulfuric acid solution (1.2 M of …
enriched manganese ore were 58.83%, 26.57%, and 38.33%, respectively, when the grade of 0.074 mm fraction with 80% of manganese ore. As a result of the shaking table tests, the manganese content in the concentrate was 35.84% and, the metal recovery and yield were 50.57% and 24.43%, respectively, for the manganese ore fraction
Mn contents of these ores ranged from 2 to 30 pct. Column-leaching of 11 ore samples containing primarily pyrolusite, psilomelane, and/or wad resulted in 73- to 97-pct Mn extraction, with an average extraction of 86 pct. Column leaching of three ore samples containing primarily manganese carbonates, two ore samples containing …
For all systems tested, leaching efficiencies based on removal of manganese from ore ranged from 83 to 90 percent. Also included in phase 1 was a brief study of residue agglomeration. The purpose was to show that pellets having both good green and excellent fired strength can be made readily from the leached umber residue.
Manganese ore-based wet flue gas desulfurization (MFGD) is a resourcing technology capable of simultaneously reutilization flue gas sulfur dioxide (SO2) and …
The results indicated that manganese oxide ore can be reduced by alkali lignin by microwave roasting at a weight ratio of alkali lignin to ore 50% and a roasting temperature 150°C for 5 min, and under these roasting conditions, a leaching ratio of manganese of 97.43% was obtained from manganese oxide ore with Mn content of …
Manganese leaching and recovery from pyrolusite ore, was investigated by using H 2 SO 4 as a leachant and H 2 O 2 as a reducing agent. The effects of agitation, H 2 O 2 concentration, H 2 SO 4 concentration, liquid/solid mass ratio, leaching time and reaction temperature on manganese recovery were studied. The optimal leaching …
The leaching efficiency of Xiangxi manganese oxide ore reached 99.8% under the optimal condition which was determined as follows: manganese oxide ore to waste tea mass ratio of 10:1, sulfuric acid ...
Effects of the mass ratio of manganese ore to sawdust, roasting temperature and time, leaching temperature and time, leaching agent concentration and liquid-solid ratio were studied. 97.71% of ...
The increasing global demand for Mn necessitates cost-effective recovery methods applicable to low- and medium-grade ores. Reductive bioleaching has …
The present study focuses on the leaching of MnO2 form manganese ore by acid leaching method using glucose as a reducing agent. The leached MnO2 was used to prepare nano LaxCa1-xMnO3 and LaxSr1 ...
The reductive leaching of manganese from a low-grade manganese oxide ore was investigated by using pretreated sawdust as …
Selective-reductive leaching of manganese from low-grade manganese ore using tannic acid as a reductant in acidic media was demonstrated by XRD, SEM-EDX …
Mn was extracted from low-grade manganese dioxide ore by reductive leaching. • Electric field enhancement leaching process was developed. • The macroscopic kinetic equation was established, and the Ea was 19.68 kJ/mol.. The cycling of Fe 3 + and Fe 2 + ensure the high leaching efficiency of the process.
Effect of various parameters on in-situ leaching of manganese ore with P. citrinum such as (a) particle size (b) pulp density (c) sucrose concentration (d) inoculum size and (e) duration of ...