The single minerals, chalcopyrite and pyrite, were obtained from GEOdiscoveries, Australia. Their elemental compositions were analysed by ICP-MS and shown elsewhere (Mu and Peng, 2019).The XRD patterns of chalcopyrite and pyrite samples are shown in Fig. 1 (a) and (b), respectively. The impurities in chalcopyrite are …
ادامه مطلبFormation of hydrogen peroxide (H2O2), an oxidizing agent stronger than oxygen, by chalcopyrite (CuFeS2), which is a copper iron sulfide mineral, during grinding, was investigated.
ادامه مطلب1. Introduction. Metal ions that commonly exist in flotation pulp, such as Cu 2+, Pb 2+, and Ca 2+, can cause the non-selective activation of metallic sulfides and gangue particles in the separation of metallic sulfide ores by flotation.In most cases, these metal ions are also known as unavoidable ions. Recently, several researchers …
ادامه مطلبThe effects of ceramic balls (CB) and cast iron balls on grinding and flotation performances were compared. • Grinding with CB exhibited lower Fe 3+, Cu 2+ concentration and pH, as well as higher DO.. Grinding with CB resulted in smoother surface, less floccules, better hydrophobicity and lower iso-electric point.. Grinding with …
ادامه مطلب1. Introduction. Chalcopyrite (CuFeS 2) is one of the primary copper sulphide minerals and it accounts for 70–80% of the global copper (Cu) reserves (Baba et al., …
ادامه مطلبIn saline water flotation, the salinity can cause a distinguishable slime coating of clay minerals on chalcopyrite particles through its effect on their electrical double layers in aqueous solutions. In this work, kaolinite was used as a representative clay mineral for studying slime coating during chalcopyrite flotation. The flotation of …
ادامه مطلب• Magnetite pellet feed recovery from chalcopyrite dam copper otation tailings. • Process route comprises scalping screen, low eld rougher, and cleaner magnetic separations and silicates reverse cationic otation as recleaner step. • High-quality magnetite pellet feed reaching 68.00 wt% of Fe, 2.13 wt% of SiO 2, and 95.1 wt% of magnetite.
ادامه مطلبThis study focused on the selective galena depressive mechanism of tea polyphenol in chalcopyrite flotation. The mixed mineral flotation experiments yielded a copper recovery rate of 83.07 % and a copper grade of 29.32 % for the copper concentrate, as well as a lead recovery rate of 91.13 % and a lead grade of 71.37 % in the lead …
ادامه مطلبThe finer the material, the greater is the percentage of recovery; the pyrite should pass at least a 170-mesh screen in order to get efficient flotation under the conditions of the tests. Of the many factors affecting flotation, only two—the oil and the other agent used—were made variable.
ادامه مطلبPart of large-scale industrial test results of milling fineness influence on lead, copper and zinc minerals flotation results in the Rudnik flotation plant are shown in this paper. Based on industrial research it has been concluded that one-stage milling and two-stage classification of complex Pb-Zn-Cu ore leads to so-called "differential milling". …
ادامه مطلبIn the dry screening process, the standard screen was used, and the operation was carried out in strict accordance with the specified screening time and ... The impact of DAHP dosage on the flotation of chalcopyrite and molybdenite is depicted in Fig. 3. The results indicated that both minerals were difficult to separate by flotation …
ادامه مطلبThis paper investigated the effects of using or not using potassium butyl xanthate (PBX) as a collector on the flotation kinetics of talc and chalcopyrite. By means of atomic force microscopy (AFM), Fourier-transform infrared spectroscopy (FTIR), a contact angle measuring instrument and particle size analyzer, the underlying causes …
ادامه مطلبThe flotation experiments of pure chalcopyrite with slurry flow rate of 0.4 m 3 / h and 0.5 m 3 / h and median diameter d50 = 45 μm were carried. The particle transport equation …
ادامه مطلبThe chunk chalcopyrite samples were artificially crushed and ground in an agate mortar by a pestle, and then dry-screened. The fraction with a diameter ranging from 38 to 76 μm was adopted for flotation and adsorption tests.After being washed 3 times (1 min per time) in distilled water under an ultrasonic bath, the chalcopyrite fraction was …
ادامه مطلبDOI: 10.7939/R3NK91 Corpus ID: 103904804; The Role of High Molecular Weight Polyethylene Oxide in Reducing Quartz Gangue Entrainment in Chalcopyrite Flotation by Xanthate Collectors
ادامه مطلبA novel collector IBATC was synthesized and used in the flotation separation of chalcopyrite, pyrite and sphalerite. IBATC can effectively separate chalcopyrite from sphalerite and pyrite with pH of 9.5–10 and concentrate of 30–40 mg/L. IBATC chemically adsorbed on chalcopyrite surface, whereas physically adsorbed on sphalerite and …
ادامه مطلبIn this paper, a novel surfactant, N,N-diethyl-N ′-cyclohexylthiourea (DECHTU) was synthesized and first introduced as a collector for chalcopyrite flotation.The micro-flotation results demonstrated chalcopyrite with adsorbed DECHTU exhibited good hydrophobicity and was effectively concentrated by nitrogen bubbles …
ادامه مطلبThe lattice energy of chalcopyrite is close to 17,000 kJ mol −1, and the standard enthalpy of formation ΔH f and the standard Gibbs free energy of formation ΔG f ° values are −193.6 and −190.6 kJ mol −1, respectively.These ΔH f and ΔG f ° values are in the common range for sulfide minerals and do not explain the recalcitrance and unfavorable kinetics of …
ادامه مطلبFig. 2 (a) illustrates the relationship between the flotation results of chalcopyrite and molybdenite and pH value of pulp at collector dosage of 1×10 −5 mol·L −1.As depicted in Fig. 2 (a), pH value exerts negligible impact on the flotation performance of chalcopyrite, while it significantly affects the recovery of molybdenite. Compared with …
ادامه مطلبTECHNICAL ARTICLE Selective Adsorption Mechanism of Ferric Ions on the Surfaces of Chalcopyrite and Pyrite in Flotation FENG ZHANG,1 CHENYANG ZHANG,1,2,6 HONGLIANG ZHANG,1 PAN CHEN,3 RONG WANG,1 DAIXIONG CHEN,4 JIANHUA CHEN,5 MENGJIE TIAN,1 and WEI SUN1 1.—Engineering Research Center of Ministry …
ادامه مطلبIt is difficult to separate molybdenite and chalcopyrite by froth flotation due to the good floatability of the two minerals. In this paper, the separation of copper–molybdenum sulfide minerals was realized by using pullulan polysaccharide (PU) as the depressant. The flotation test results showed that the copper concentrate grade …
ادامه مطلبIn the paper, the flotation of a porphyry copper ore in the NovaCell is described. The head grade was 1.0% Cu, and the copper mineral was freed from encapsulation at a …
ادامه مطلبAcid mine drainage (AMD) released from copper sulfide contains a large quantity of sulfuric acid and heavy metals, thus being a threat to the surrounding ecosystem. In this study, AMD is used to evaluate options for activation of chalcopyrite depressed by a high alkali solution (HAS). The results showed the flotation recovery of …
ادامه مطلبOne of the problems in flotation is mechanical entrainment and the other is the presence of complex gangues (especially clay minerals). In the present study, it was aimed to determine the effects of clay types (kaolinite, illite, and montmorillonite) on mechanical entrainment parameters (total flotation recovery, real recovery, mechanical …
ادامه مطلبStudies have also shown the uses of non-toxic and bio-degradable organic materials as the galena depressants for Cu-Pb sulfide minerals separation. For example, Zhang et al. [4] used sodium polyaspartate to hinder galena in chalcopyrite flotation under a weakly alkalinized pulp environment, resulting in a high-quality copper-bearing product.
ادامه مطلبThe flotation results indicated that L-cysteine exhibited stronger depressing ability than the conventional chalcopyrite depressants of Na2S, NaHS and sodium thioglycolate, suggesting it could ...
ادامه مطلب1. Introduction. Froth flotation process separates solid particles based on the differences in physical and surface chemistry properties. It is the most efficient and cost effective for particles within a narrow size range, nominally from 10 to 100 μm for the minerals [1], [2].The lower and upper particle size limits are due to the low probability of …
ادامه مطلبDFT calculations further reveal that TBOEX can form a stable and tightly arranged adsorption layer bridged by water molecules on the surface of chalcopyrite through two paths, and interact with d orbitals of copper atoms in the form of Cu-S tetrahedra through π* orbitals, finally improving the flotation recovery of chalcopyrite.
ادامه مطلبFig. 2 shows chalcopyrite flotation recovery in the pure water, sea water and 0.05 M MgCl 2 solutions at pH 10. The cumulative recovery was approximately 70% in pure water after 10 min, indicating a good natural floatability of chalcopyrite. An apparently lower chalcopyrite recovery of 58% was observed in sea water, especially in the initial …
ادامه مطلبThe results indicate that chalcopyrite and pyrrhotite act differently alone than in a mixture which means the presence of pyrrhotite inhibits chalcopyrite recovery. For chalcopyrite, …
ادامه مطلب